STM Pro ECU 1UZFE ECU/HARNESS/DASH, DUAL WIDEBAND

400KPA map sensor installed. until further notice.
Stm32F407
8 x injectors (high current)
8 x Ignition Output (selectable 5/12v) Coils with ignitors (Smart coils)
(Firmware will run sequential 8x8 ignition/Injection)
4 x High current (vvt , boost, idle 1, idle2)
1 x High current High side output (12 volt Positive, can drive V-Tech solenoid)
3 x low current, Fuel pump, Fan, Spare
(Total of 13 High Current outputs)
(Total of 3 Low current outputs)
Coolant
Intake air temp
TPS
MAP (internal + External) 250kpa or 400kpa internal available
O2 analog Input (Wideband and narrow)
4 x extra analog inputs 0-5v linear (Oil,Fuel pressure etc, Can be configured as temperature with bias resistor jumper)
(Total of 9 external Analog inputs)
Built in Dual VR Conditioner MAX9926 (selectable VR or HALL)
Baro Internal
Flex input
3 x Digital inputs (VSS etc)
Tach output (5v-12V Selectable)
Stepper idle (4 wire stepper) control plug in (Can be used for another 3 Medium current Outputs)
16×16 tables for injection, ignition and AFR target maps.
CAN Bus Communication (Supports OBD2, CANBUS Broadcast available with added addresses)
Quality robust USB B connector (not the crappy USB Mini connectors)
Aluminium cased
Uses Tuner Studio for tuning software
All come with both 26/34 pin connectors, Crimp pins, Wiring diagram and instructions.
All units are tested on a running engine before sending out.
Please allow approximately 5-7 day lead time for unit to be built and tested.
Every unit is hand assembled at the time of ordering. Takes me around 4 hours to assemble one unit without and accessories.
Currently Compatible with Speeduino firmware, You can read capabilities at http://www.speeduino.com
Please note these controllers are DIY EFI (Aftermarket and possibility not road legal).
The user must have some degree of knowledge of how a engine works and Electronic Fuel Injection systems and Electrical wiring.
As this is a DIY, I take no responsibility on how it is used and damage or harm it could cause.
Product Details
3.5" Pro touch screen display.
Selectable multi screens to display important information from your PRO ecu.
(This displays shares the same port as the Bluetooth and cannot be use if your using Bluetooth.)
Display:
RPM.
Air temperature.
Coolant temperature.
Battery Voltage.
Manifold pressure/ Boost pressure.
Throttle Position.
Air/Fuel ratio.
Oil Pressure.
Fuel Pressure.
Timing Advance.

Digital numbers or Analogue style gauges.
Some customisable options
Functions selectable by touch screen.
Speeduino Firmware Version 202108 or higher is required.
If your ECU has the connector on the back near the USB (see last picture for identification) then it is just Plug N Play.
this also includes Micro and Basic ecu's, Please check near the USB connector on these models and see if there is a small 4 pin connector, If there is your ready to go.
Comes with pre terminated cable ready to plug into you STM PRO, Basic and Micro ECU's (Please check before purchasing if you purchased your ECU before 11-12-2021)
Versions without connector needs small plug in module and back cover (no extra cost).
Product Details
Dual Wideband controller.
2x LSU4.9 wideband sensors inputs.
2x wideband 0-5v output.
2x simulated narrowband output.
Constant Battery connection with ignition Sense power up.
Comes with all connectors and pins.
Also supplied are 8 u5014 coils for coil on plug conversion